I ended up cutting it a little more and folding the carpet under and stapling it down at the edge of the wood that is at the top of the staircase.
Tear up carpet on stairs.
I started at the bottom corner of the stairs by using a crowbar to pry the carpet away from the tack strip.
Cut the carpet with a utility knife under the nose of the landing.
Once you get the carpet up this is what you will see.
Pull up all the carpet pad.
Grip the carpet with both hands for easier removal and to maintain balance and safety.
Find a good place to start removing carpet from stairs.
Start at the top of the stairs and remove the carpet with the vise grips and utility knife.
If not cut the carpet near the top of the top riser grab the cut end and pull the carpet off the stairs by hand.
One year ago i ripped up all of the beige carpet on my stairs.
Some stairs are covered with short sections of carpet that wrap over just one tread and riser.
I removed all of the padding tack strips nails and staples.
Wear gloves to protect your hands from the staples that hold the carpet in place.
Hopefully that will happen next summer.
This works fine for now.
Each piece of carpet was also wrapped around the edges of the stairs and around the balusters so i had to remove the staples holding it in place from underneath green arrow below.
So here is the project replace carpet with stair runner tutorial.
I have plans to install hardwoods in our upstairs hallway.
The blue stuff is the carpet padding and the arrows show where the nail strips are.
To take up all the carpet tack strips just place a flat head screw driver under the strip tap in with the hammer and gently pry it up.
Keep moving the screwdriver until the tack strip comes up.
Do this same technique with all the 3 567 987 million staples.
I repaired the treads removed.
I only want to have carpet in the bedrooms one day.
Use the vise grips to pull the carpet free from the riser.