Standing seam roofing is composed of preformed or field formed pans usually between 14 to 18 inches wide when finished.
Standing seam roof edge detail.
Other flashings include gable trim which runs up the sloped ends of the roof and drip edge or eave trim.
Panel extended eave cleat pancake head screw tube sealant.
The recommended dimensions should be specified from the table below.
The most common flashing for standing seam roofing is the ridge cap which is used at the peak of a roof where two opposing roof slopes join and attaches to the roof with z flashing.
Standing seam consists of sheet metal roofing panels joined side by side and attached to the roofing deck with concealed fasteners.
Eave trim details for standing seam eave option 1 hem around eave cleat is installed then extended eave is hooked over cleat and finally the panel ribs are cut off and the flat part is hemmed around the extended eave trim.
These pans run parallel to the slope of the roof and are joined to adjacent pans with double locked standing seams.