Installed in each pella sliding door is a mechanism that moves the location of the lower track guide.
Sliding patio door roller adjustment.
Most sliding doors have a mechanism called an adjusting screw located at the bottom of the door ends.
At this point it may not be a bad idea to spray some lubricant into the.
Tinker around with the roller screws to see if the door glides better when it s at a lower or higher height.
A sliding door will be out of alignment with the frame when the rollers need adjusting.
Making the adjustments correctly will realign the door to reduce these problems.
The sliding panel should glide across the tracks when you open the door without jamming.
Most sliding glass doors contain two sets of rollers one on each side of the bottom of the door.
Also called sliding glass doors these doors are designed to glide horizontally with one operating panel and one stationary panel.
Locate the adjustment screws on the lower edges of the door.
The rollers at the top can also wear down lowering the bottom of the door so that it rubs on the track.
In these cases the problem is usually that the rollers at the bottom of the door have started to rub against the track.
Over time the framing of your home settles.
Raise it just enough to clear the track and roll smoothly.
You can alter the height of these rollers by accessing the adjustment screws which are set into slots on the door s outer edges perpendicular with the rollers themselves.
To start your sliding glass door adjustment project first lift or lower the door on the track with a screwdriver or allen wrench.
The wheels on the glass sliding patio door have an adjustment screw at the bot.
This adjustment screw will move the roller height up or down and thus your sliding glass door height will go up or down by as much as 1 4 inch or 1 2 cm.
As the framing inside the door opening settles the tracks raise or lower with the floor.
This causes the door to bind when moved or fall off the track or may cause the lock to stop working.
Locate the two adjusting screws at the bottom of the door on the face or edge of the door and pry off the trim caps that cover the screws.
The patio door will meet the jamb at an offset angle if one roller is higher than the other.
The lock will not meet up with the frame latch unless the rollers hold the door the correct height.
Overtime pella sliding doors fall out of adjustment.
Adjusting the rollers on your pella sliding doors raises or lowers the door panel as necessary to get the door working.